NEON-LED, the new idea for NEON!!!
---SMD NEON-LED, EXTRUSIVE SMD LED FLEX-STRIP ---New!

| Home | Company Profile | Patents | On the Fair | What's New | Product Catalog | Quality Control | Show Case | Contact Us | - Group Link - |

SMD NEON-LED
NEON-LED Series
Support

 

How to use the NEON-LED?

 

Patented!!!

NEON-LED is a revolutionize new  plastic rope light which is a new idea for Neon!

 

Please follow the step as show as following photo to install the NEON-LED. For more information, please feel free to contact our technical supporter.

 

Cut the NEON-LED at Cut-Mark

Cut out the cooper wires outside

Connected to the Power Connector

Covered by Heat-Shrinkable PVC Tube and PVC Glue for waterproof

Connect by Extension Connector

Covered by Heat-Shrinkable PVC Tube and PVC Glue for waterproof

Cover the end by End Cap
Covered by Heat-Shrinkable PVC Tube and PVC Glue for waterproof
Install by Splice Connector

 

Covered by Heat-Shrinkable PVC Tube and PVC Glue for waterproof

Install by Mounting Clip

Install by Mounting Channel

 

CAUTION:

•  Do not plug the NEON-LED into power source when it is still wrapped in a roll or in a spool to avoid heating.

•  Do not plug the NEON-LED into power source before installation is fully completed.

•  Make sure power source and NEON-LED should have the same voltage.

•  The lamps can not be replaced and can not repaired. If power cord is damaged, replace the same one from supplier.

•  To avoid fire and shock hazard, do not use when outer insulation is damaged.

•  NEON-LED can ONLY cut at the indicated mark.

•  Do not cover NEON-LED by any object or material when it is in use.

•  The end of NEON-LED must be fully insert into the End Cap and fixed tight.

•  For outdoor use, add silicon glue on the connectors and end cap for waterproof. And, if it is necessary, add additional heat-shrinkable tube for sealed use.

 

If you need a new product, please feel free to contact us and speak to one of our friendly sales representatives.